Usually, the car seat adjustment switch is located on the side of the seat. According to the adjustment direction, it can be divided into front and rear adjustment, height adjustment, backrest adjustment, waist adjustment, pillow adjustment, etc.
Before adjusting the seat, press your body against the seat and try not to create a gap between your body and the seat.
1. Seat height adjustment: Make sure eye level is in the middle of the windshield.
The adjustment of the seat height is mainly to adjust the sight height and adjust the visibility of the front range of the vehicle. Adjustment requirements ensure that the eye level line of sight is slightly higher in the middle of the windshield; after opening the sun visor, the horizontal downward line of sight is not affected by the sun visor; when the head is raised normally, the distance between the head and the roof is at least There are two fingers apart.
2. Seat back adjustment: mainly for comfort.
There is no clear adjustment basis for the adjustment of the seat back, which is mainly based on comfort. According to our own driving preferences, the angle of the backrest cannot be half-lying or too vertical.
Ensure the largest possible contact area with the back, and occasionally switch the backrest angle to ease lumbar pressure during long-term driving. The lumbar support adjustment is very important for drivers who often drive long distances, but it is not recommended to adjust the lumbar support too high or too low, it is better to be moderate. If it is too high, the driving time will increase and the lower back will hurt.
3. Seat front and rear adjustment: Adjust according to the position of the vehicle pedals.
The front and rear adjustment of the seat is mainly adjusted according to the position of the vehicle pedals. If the distance between the seat and the pedals is large, the driver will be more comfortable to stretch their legs, but the accuracy and strength of the pedals will be less. Fully depress the brake pedal with your right foot and fully depress the clutch pedal with your left foot or rest on the left foot rest pedal. At this time, the distance between the front and rear of the seat is adjusted, and when the pedal is fully depressed, the driver's knee is bent to a certain extent.
4. Headrest adjustment: should be flush with the head or the soft part in the middle of the headrest should be parallel to the upper edge of the ear.
The adjustment of the headrest is also very important. If the height of the headrest is too high, the back of the head can only touch the lower edge of the headrest, and the cushioning effect of the headrest hardly works. If the height of the pillow is too low, the result will become more serious. If the vehicle collides, the head will reversely hit the pillow at the moment of inertia. If the height of the pillow is too low, the neck will hit the pillow in the state of whiplash, and the fatal wound of cervical vertebra fracture . The contact position between the pillow and the head should be offset at eye level, and the distance between the pillow and the head should be as close as possible and no more than 7 cm away. The approximate height should be parallel to the soft part between the head and pillow and the upper edge of the ear. Because the pillow is the softest and the most protected part is the middle of the pillow, when the vehicle is severely impacted, the pillow can effectively protect the head and cervical spine.

